|Operating Voltage:||120VAC 50Hz/60Hz||Microwave Frequency:||5.8GHz±75MHz|
|Microwave Power:||<0.3mW||Mounting Height:||2.5-6m/8.2-19.68ft (ceiling Mounted)|
|Detection Range:||Radius, 3-6m/9.84-19.68ft (ceiling Mounted)||Warranty:||5 Years|
IP20 UL FCC Certificated Dimmable Motion Sensor Microwave Power <0.3mW
ON/OFF Function Microwave Motion Sensor HD402S-6 with Slim Design which could be Applied to Linear Light / Tri-proof Light with Built-in Installation Way
1. DIP switch setting for all parameters like hold time, daylight threshold and detection area.
2. Radar Microwave Sensor with ON/OFF Switch Function.
3. 4 pole pluggable clamp terminal(L.N.N.L') for 1.5mm² cable.
4. IP20 and 5 years warranty.
5. UL FCC certificate.
|Input||Operating Voltage||220-240VAC 50/60Hz|
|Output||Load Type||Max. 400W (Control gear); Max.800W(Incandescent lamp)|
|Detection area||10% / 50% / 75% / 100%|
|Mounting Height||Max.6m(ceiling mounted); Max.3m(wall mounted)|
|Detection Range||Max.14m(ceiling mounted); Max.10m(wall mounted)|
|Operating Frequency||5.8 GHz ±75 MHz|
|Certificate||Certificate Requirement||CE / TUV / RED|
|Others||Wiring Method||4-pole terminal (Input grey L. N. Output grey N. L’)|
|IP Rating||IP20 (Built-in)|
|Packaging Requirement||Bubble bag +Outer Carton(K=A)|
ON/OFF Daylight Sensor Detection Area Warranty 5 years Hold time
With a slim design, it's a little longer but very thin for linear light and tri-proof light.
With a protruding module, it will need to remove a very few light bead on the board to expose the module out of the metal board
Simple wiring way with four terminals:
"N,L" connecting with power supply and "N,L'" connecting with LED driver.
Max. detection range will be 12m for ceiling mounted; Max. Detection range will be 10m for wall mounted.
Typically installation height 2.5-6M. This figure indicates the maximum distance at the highest mounting height with 100% sensitivity.
DIP Switch Settings
1&2 to set detection area.
movement will be detected and able to trigger the sensor.100% detection area is also known as the strong sensitvity.
|3&4 to set Hold-on time
The period of light keeping 100% brightness after moving objects leave the detection area.
|5&6 to set Daylight threshold
Definition of the ambient brightness; only when the ambient brightness is lower than the preset specific lux amount, the sensor will work; when it's preset as "disable",the sensor works everytime it detects motion regardless the ambient brightness.
1. Automatically ON/OFF function
Light on when detect movement and off after people leave at night. Applications: Corridor, Staircase.
2. No daylight function
The daylight threshold is set to "Disable".
Light on when detect movement, After people leave, Light off after hold on time. Applications: Dim places such as Basement Parking, Underpass.